ProScreen ® 6 Panel Multi-Drug Test Card Six parameter, All Inclusive Multiple D rug of Abuse Test (Dip Screen type)   THC (MARIJUANA) • COCAINE  • OPIATES • OXYCODONE  • BENZODIAZEPINES •  METHAMPHETAMINE (inc. ECSTASY* )   TEST PROCEDURE •  Read the enclosed instruction manual completely. •  Do not open the sealed test pouch until just prior to sample testing. •  Collect a fresh urine sample in a clean container preferably glass. • Check the expiration date and remove the test device from the sealed pouch. Do not use the test past its expiration date. Remove the test cap exposing the 6 absorbent wicks. Do not touch the wicks or otherwise contaminate them. •  Dip the wicks only into the urine sample for approximately 20-30 seconds or until visible sample migration up the wicks and across the tests panels is observed .  •  Dip only the wicks. Do not allow the sample to come in contact with any other part of the test device or its plastic housing . •  Read result within 3 to 8 minutes after the addition of samples. Do not read result after 8 minutes. If the drug test is left standing for longer than 8 minutes, the intensity of the colored lines may change or for technical reasons, a faint line may appear that should not be interpreted. •  Photocopy the developed test card for a permanent record of test results. INTERPRETATION OF TEST RESULTS Negative : Colored lines adjacent to each target drug name and in the control (C) regions will appear. The color intensity of the line for the target drug may be weaker or stronger than that of the control line however any line, no matter how faint should be interpreted as a negative result. Do not attempt to correlate the intensity or color of the test lines between the targeted drug panels. Also because development times vary for each target drug, results should not fully interpreted until 6-8 minutes have elapsed. Some drug panels, however, will develop test lines within 3 minutes or less producing negative results. A very faint line on the test region may indicate that the target drug in the sample is near the cutoff level for the test. While these results should be considered negative, confirmation of the sample by more analytical testing methods may be desired. Positive : Colored lines appear in the control regions (C) but do not develop in the test region. The absence of any line in any target drug test region indicates a positive result for that drug or drug metabolite. The example shown is a positive test for OXY (oxycodone) and MET (methamphetamine #1) and negative test for all other drugs. Note that test lines are not of equal intensity or color. Because of the various sensitivity cutoff level for each specific drug this result is normal. Also note that the first strip tests for two drugs on the same strip and shows two test areas #1 and #2. #1 test area corresponds to 1 MET and #2 test area corresponds to 2 OPI. Hub : 0856 9139 8333. 021-4091 1748